|
Frequently Asked Questions
How does the KVAR Energy Controller Work?
The KVAR Energy Controller reduces the amount of power drawn from the utility by storing (in its capacitors) otherwise lost electricity (watts) caused by the inductive motors in your home. Some examples of inductive motors are HVAC systems, refrigerators, freezers, air compressors, washers, dryers, dishwashers, pool pumps, furnace blower motors, fans etc. The technology applied by the KVAR Energy Controller supplies that stored electricity back to your inductive loads, thus causing you to decrease your demand from the utility company. If you decrease your demand from the utility company, your meter slows down, and you use less electricity.
What is Power Factor?
Power factor is a measure of how effectively the current is being converted into useful work output. For example, a 1.0 power factor means that all the electricity that’s being delivered to your home is being used effectively 1000 kW = 1000 kVA. At 70% power factor, 1000 kW = 1429 kVA. The utility company would need to increase an additional 429 kW to satisfy a 1000 kW load operating at a 70% power factor. In short, improving the power factor at the distribution system and at the load equates to less losses and more efficient use of the energy produced. KVAR Energy Controller increases that power factor, thus increasing the effective use of your electricity
Does the KVAR Energy Controller work in any home?
Yes it does, as long as you have a circuit breaker panel with breaker switches and not the old screw in type fuses, the unit will work on any single-phase electric application for homes.
Do you have a 3-phase KVAR Energy Controller?
Yes!
Will the KVAR Energy Controller affect any of my appliances and their normal use?
No, if anything, your motors will run about 10% cooler, which is good for a motor because heat can cause damage to the motor.
Is the KVAR Energy Controller tested and approved by independent labs?
Yes, the KVAR Energy Controller is UL listed. Also, the technology is recognized by the U.S. Department of Energy and NASA tested (results on certification page).
How much can I expect to save per month by using the KVAR Energy Controller?
That depends on many factors. The size of your home, the amount of inductive motor load, and the amount you are paying per kilowatt-hour for electricity etc. However, users of the KVAR Energy Controller have seen up to 35% in reduced consumption, but the average savings is somewhere in the 8% to 10% range.
How long will it take for the KVAR Energy Controller to pay for itself?
Generally about 12-24 months, but again, the same factors above apply, some will see sooner (12 months), some will see later (24 months).
Is the KVAR Energy Controller easy to install?
A licensed electrician must do installation; to do otherwise voids the warranty. The unit comes with complete installation instructions. It installs in about 20-30 minutes.
How long will the KVAR Energy Controller last?
It has a predicted lifespan of up to 20 years.
Does the KVAR Energy Controller provide Surge Protection?
The KVAR Energy Controller protects the entire home against power surges. The KVAR Energy Controller is attached to the top 220/240-volt breaker/200amp service. By installing the KVAR Energy Controller in this location, you are hitting both sides of the bus bar in your panel insuring amperage surge protection. No longer a need for so many surge protectors in the home. The KVAR Energy Controller provides amperage surge protection for all your home equipment, such as televisions, entertainment systems, computers etc.
Is the KVAR Energy Controller Warranted?
Yes, 5 year Manufacturers Warranty for full replacement. See our warranty on our website for full details.
|
|